service reps told me that this drill press takes 'Metric T-slot nuts. By the way, I forgot to mention that one of the Delta tech. The 5/8' T-slot nuts (1-1/8' long) won't drop down enough to slide into the slots. The four "runners" hold the auxiliary table in place with no movement.ĭon't overthink it, the steel table is solid as it is as long as you don't make your new table much wider than your original steel table. In other words, at the top its width is 1-1/8' but at the bottom its width is 1'. Next I glued/ laminated another piece of wood to that one for double thickness. With the first layer oversize, I squared the back edge with the runners, then squared the other three sides on the tablesaw. Waited about five minutes, removed the auxiliary table, turned it over, pin nailed the runners, and scraped off any excess glue. Like attaching runners on a tablesaw sled or jig. I have the same table and I cut four short "runners" (think table saw runners), rounded the ends so they fit nicely in the ends of the steel tracks in the table, placed some pennies in the slots to raise the runners just above the steel table, put the runners with glue on them in the slots, then set my first layer (oversize) of my new table down on the wet glue.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |